Cameo ZENIT W600 D SMD Manuel D'utilisation page 18

SLAVE MODE CONFIGURATION
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
Slave (observe arrow) and confirm with ENTER. Connect the slave and the master units (same
model, same software version) with a DMX cable and enable a standalone mode (Static, Pixel) on
the master unit. The slave unit will now follow the master unit. If there is no control signal, the
display characters will flash. Flashing stops as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
SYSTEM SETTINGS (SETTINGS)
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
Settings (observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (selection with UP and
DOWN, confirm with ENTER):
Settings
Wireless = W-DMX
Settings
18
Mode
Slave
W-DMX On/
settings Off
(wireless
Operating
DMX)
Mode
Transmitting
Mode
Link
Receive
Reset
On = W-DMX activated
Off = W-DMX disabled
Receive = W-DMX module as receiver
Transmit = W-DMX module as transmitter
G3 = G3 transmission standard
G4S = G4S transmission standard
Link = pair with W-DMX devices. W-DMX must
be activated on all devices and the pairing
must be picked up by a transmitter (Receive
Reset).
Unlink = unpair all devices
No = do not retain transmitter pairing
Yes = retain transmitter pairing