Dymo M1 Guide D'utilisation page 8

Troubleshooting
Problem/Error Message
No display
LO is displayed
Negative number is displayed
00000 is displayed
Display reads 0 g, 0.0 oz, or 0.00 oz with
an item on the platform
If you need further assistance, you can obtain support at www.dymo.com.
Warranty
TWO-YEAR LIMITED WARRANTY
Dymo scales are sold with a two-year warranty from the date of purchase against defects in design, materials and
workmanship. If this product is found to be defective within that time, we will promptly repair or replace it at our cost.
This warranty does not cover accidental damage, wear and tear or consequential or incidental loss.
WHAT IS COVERED?
This warranty covers this product only and only against defects in design, materials or workmanship. If, after inspection of
your returned product, we find that the product is defective in design, materials or workmanship, we shall at no charge to
you repair or replace the product at our discretion, and return the product to you. You are responsible for the full cost of
shipping the product to Dymo, but there is no charge for the inspection or the return postage.
WHAT IS NOT COVERED?
This warranty does not cover loss of or damage to a computer or other devices connected directly or indirectly to this
Dymo product. This warranty also does not cover any loss of or damage to data, programs, records or other information.
This warranty does not cover any defect or loss which would not have occurred if instructions in the owner's manual had
been followed. This warranty does not cover other incidental or consequential damages even if Dymo has been informed
of the possibility of such damages. This warranty is in lieu of all other warranties, express or implied. This warranty gives
you specific rights and you may also have other rights, which may vary from state to state or country to country.
HOW TO MAKE A WARRANTY CLAIM
To make a warranty claim, please contact customer support: www.dymoservice.com
2 + 1 Year Warranty - Register
Register now at www.dymo.com/register and extend your limited warranty for one additional year.
It is easy to register online. You will be sent a three-year warranty certificate and benefit from:
1. Technical support
2. Special offers and other interesting information
4
Solution
Replace the batteries.
Replace the batteries.
A tare value is displayed as a negative number when the items
are removed from the scale. Press
The item on the scale platform exceeds the maximum capacity
of the scale. Remove the item immediately to prevent damage
to the scale.
This can happen because:
• The Tare/Zero button,
the scale.
• Power to the scale was disconnected or turned off and then
on again with an item on the scale.
In both of these cases, remove the item from the platform and
press to return the display to 0 g, 0.0 oz, or 0.00 oz.
to reset the scale to zero.
, was pressed while an item was on