Costan TORTUGA 2 Mode D'emploi page 30

For best cabinet operation we recommend:
• loading the products as explained in the preceding section;
• Never leave upper glass sliders open or ajar (fig. 17). It is advisable to often check that all sliders are closed: you
will thus avoid unnecessary energy consumption and frost build-ups on the walls and you will also allow better foods
preservation.
DESCRIPTION OF CONTROLS
The Tortuga display cases have a control panel in the base. This control panel lodges a remote thermometer/remote
thermostat for temperature display and control through appropriate keys.
Temperature regulation is restricted to the after-sales personnel.
Do not remove the panel protecting of the electric control board for no reason whatsoever.
DEFROSTING
The number and duration of defrosts of the cases are factory-set.
The user must never alter defrost adjustment.
The cases are supplied as including a U-trap for their connection to the sewer system (WHICH MUST BE CARRIED OUT
BY THE AFTER-SALES SERVICE IN CHARGE OF INSTALLATION).
9. PRESCRIPTIONS AND RESTRICTIONS
KEEPING PHARMACEUTICAL PRODUCTS, GLASS BOTTLES OR FLASKS IN THE DISPLAY CASE IS STRICTLY
FORBIDDEN as they could get broken and entail a safety hazard (fig. 16).
Do not remove covers or panels when it requires the use of tools. DO NOT REMOVE THE ELECTRIC
CONTROL BOARD COVER.
Caution: never remove the glass sliders. The cabinet was designed to only work with the sliders on.
Do not expose the display case to atmospheric agents (fig. 20).
Do not spill water directly or indirectly on the display case (fig. 19). Do not touch the machine with damp
or wet hands or feet; do not use it while barefoot (fig. 21).
Do not step on the bumper rail.
ANY OTHER USE NOT EXPLICITLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED AS HAZAR-
DOUS. THE MANUFACTURER DISCLAIMS ALL LIABILITY FOR ANY DAMAGE RESULTING FROM IMPRO-
PER, INCORRECT OR UNREASONABLE USE.
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE MAINTENANCE OR CLEANING, DISCONNECT THE REFRIGERATOR FROM THE
POWER SUPPLY USING THE WALL MAIN CUTOFF SWITCH (fig. 22).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area is
sufficient. If necessary, use an additional source of light. Mind also the hot and moving parts marked
with the relevant symbol. The use of heavy-duty gloves is recommended.
QUM000188E - rev. 00 21