Urmet 1092/710 Manuel De L'utilisateur page 7

INSTALLING THE DOME CAMERA WITH POWER BOX 1092/709 ON THE
After identifying the correct installation point, use the base of the bracket as 'drilling

template'. Make the position of the four holes to be drilling on the surface.

Pass the connection wire exiting from the Power Box into the bracket itself and lead it
out from the opposite side.

Fix the Easy Dome bracket to the Power Box (4 screws and 8 washers provided with
the Power Box).

Connect the wire exiting from the bracket to the wire with the Dome connector.

Fix the bracket to the Power Box using the holes present in the front part.

Fix the dome camera to the bracket using the three M4 screws included.

Tighten the lock screw on the upper part of the bracket.
-
DS1092-240
CEILING
7