Incorrect Measurement; Disposal - Beurer SR BF 2 Mode D'emploi

Pèse-personne impédancemètre
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

• If your weight increases over the medium term and the body fat percentage falls or stays the same, then
you could have built up valuable muscle mass.
If your weight and body fat percentage fall simultaneously then your diet is working – you are losing fat
mass. Ideally you should support your diet with physical activity, fitness or power training. By this means,
you can increase your muscle percentage over the medium term.

7. Incorrect measurement

If the scale detects an error during weighing, „FAT
If you step onto the scale before "0.0" appears in the display, the scale will not operate properly.
Possible causes of error:
– The maximum load-bearing capacity of 180 kg
(396 lb, 28 st) was exceeded.
– The electrical resistance between the electrodes
and the soles of your feed is too high (e.g. with
heavily callused skin).
– Your body fat lies outside the measurable range
(less than 5 % or greater than 80 %).
– Your percentage of water lies outside the measu-
rable range (less than 43 % or greater than
75 %).

8. Disposal

Empty, completely flat batteries must be disposed of through specially designated collection boxes,
recycling points or electronics retailers. You are legally required to dispose of the
batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
For environmental reasons, do not dispose of the device in the household waste at the end of its
service life. Dispose of the device at a suitable local collection or recycling point.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment). If you have any questions, please contact the local authorities responsi-
ble for waste disposal.
" or "
" appears in the display.
Remedy:
– Only weigh the maximum permissible weight.
– Repeat weighing barefoot. Slightly moisten the
soles of your feet if necessary. Remove the cal-
luses on the soles of your feet if necessary.
– Repeat weighing barefoot.
– Slightly moisten the soles of your feet if neces-
sary.
– Repeat weighing barefoot.
– Slightly moisten the soles of your feet if necessary.
14

Publicité

Table des Matières
loading

Table des Matières