Toto TSMA Manuel D'installation Et D'utilisation page 4

IMPORTANT: For proper installation and smooth operation, the valve must
be level and square to the finished wall.
• Install the valve so that the outside surface of the finished wall will be
between the Max and Min markings on the plaster guard.
• Make sure the valve is installed with the small arrow pointing in the
direction of the water flow.
• Dashed pipework and fittings shown are not included.
• The plaster guard should remain in place until you are ready to install the trim.
OUTLET
ARROW MUST
POINT IN
DIRECTION OF
WATER FLOW
MIXED WATER
INLET
INSTALLATION PROCEDURE
2-1/2" [65mm] MIN.
3-3/4" [95mm] MAX.
4
FINISHED WALL
SURFACE
MIN./MAX.
MARKINGS