Operation; First Use; Daily Use - ZANKER KBU14001DK Notice D'utilisation

• This product must be serviced by an authorized Serv-
ice Centre, and only genuine spare parts must be
used.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its refrig-
erant circuit or insulation materials. The appliance shall

Operation

Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
Switching off
To turn off the appliance, turn the Temperature regulator
to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature regulator toward higher settings
to obtain the maximum coldness.

First use

Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm water
and some neutral soap so as to remove the typical smell
of a brand-new product, then dry thoroughly.

Daily use

Movable shelves
The walls of the refrigera-
tor are equipped with a
series of runners so that
the shelves can be posi-
tioned as desired.
12
not be discarded together with the urban refuse and rub-
bish. The insulation foam contains flammable gases: the
appliance shall be disposed according to the applicable
regulations to obtain from your local authorities. Avoid
damaging the cooling unit, especially at the rear near
the heat exchanger. The materials used on this appli-
ance marked by the symbol
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or the
appliance is fully loaded, and the appliance is set to the
lowest temperatures, it may run continuously causing
frost to form on the rear wall. In this case the dial must
be set to a higher temperature to allow automatic
defrosting and therefore reduced energy consumption.
Important! Do not use detergents or abrasive powders,
as these will damage the finish.
are recyclable.