Perel LAL3C5J Mode D'emploi page 5

4. Overview
Refer to the illustrations on page 2 of this manual.
1 dimming
2 red, green and blue setting
3 single colour selection
4 battery compartment
5 on-off switch
6 warm white
7 fast RGBW colour change
8 normal RGBW colour change
9 slow RGBW colour change
10 very slow RGBW colour change
5. Remote Control
Battery
Refer to illustration on page 2 of this manual.
The remote control uses 1 battery type 3 V lithium CR2025
(included). Remove the tag from the battery compartment before
use.
1. To (re)place a battery, press on the side of the battery cover
and pull to slide open.
2. Insert the battery with the correct polarity and close the battery
compartment by pushing back into the housing of the remote
control until it snaps into place.
Operation
1. Aim the remote control towards the LED lamp to control the
output.
2. Switch on the LED lamp with the ON button on the remote
control. To switch it off again, press the OFF button.
3. Refer to chapter 5. Overview for more information about
operating the remote control.
6. Cleaning and Maintenance
Wipe the lamp and remote control with a damp cloth occasionally to
keep it looking new. Do not use harsh chemicals, cleaning solvents or
strong detergents to clean the detector.
V. 01 – 19/09/2017
LAL3C5J
5 ©Velleman nv