DeWalt DC800 Guide D'utilisation page 10

LEAVING THE BATTERY IN THE CHARGER
The charger and battery pack can be left connected with the red
lights glowing indefinitely. The charger will keep the battery pack
fresh and fully charged. This charger features an automatic tune-up
mode which equals or balances the individual cells in the battery
pack to allow it to function at peak capacity. Battery packs should
be tuned up weekly or whenever the battery no longer delivers the
same amount of work. To use the automatic tune-up mode, place the
battery pack in the charger and leave it for at least 8 hours.
Important Charging Notes
1. Longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 65 °F
and 75 °F (18 °–24 °C). DO NOT charge the battery pack in
an air temperature below +40 °F (+4.5 °C), or above +105 °F
(+40.5 °C). This is important and will prevent serious damage to
the battery pack.
2. The charger and battery pack may become warm to touch while
charging. This is a normal condition, and does not indicate a
problem. To facilitate the cooling of the battery pack after use,
avoid placing the charger or battery pack in a warm environment
such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a lamp or other
appliance;
b. Check to see if receptacle is connected to a light switch which
turns power off when you turn out the lights;
c. Move charger and battery pack to a location where the
surrounding air temperature is approximately 65 °F–75 °F
(18 °– 24 °C);
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
5. Under certain conditions, with the charger plugged into the power
supply, the exposed charging contacts inside the charger can
be shorted by foreign material. Foreign materials of a conductive
nature such as, but not limited to, grinding dust, metal chips, steel
wool, aluminum foil, or any buildup of metallic particles should be
kept away from charger cavities. Always unplug the charger from
the power supply when there is no battery pack in the cavity.
Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING: Shock hazard. Don't allow any liquid to get inside
charger. Electric shock may result.
WARNING: Burn hazard. Never attempt to open the battery pack
for any reason. If the plastic housing of the battery pack breaks or
cracks, return to a service center for recycling.
Storage Recommendations
1. The best storage place is one that is cool and dry away from
direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool dry place out of the charger for optimal
results.
NOTE: Battery packs should not be stored completely depleted of
charge. The battery pack will need to be recharged before use.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
8