FALMEC diamante Mode D'emploi page 19

USING THE RADIO CONTROL
WARNINGS!:
Place the hood away from sources of electromagnetic waves (e.g. micro-
wave ovens), which could interfere with the radio control and with the hood
electronics.
The maximum operating distance is 5 metres, that may vary according to the pres-
ence of electromagnetic interferences.
Radio control operated at 433.92MHz.
The radio control consists of two parts:
- the receiver built into the hood;
- the transmitter shown here in the igure.
DESCRIPTION OF TRANSMITTING COMMANDS
ACTIVATION PROCEDURE
Before using the radio control, follow the procedure below on the hood pushbutton panel:
Press LIGHT ( ) and TIMER ( ) simultaneously until all LEDs start lashing.
•
Release the two keys and press LIGHT (
•
Release LIGHT ( ): now the receiver is active.
•
This procedure is also used to deactivate the receiver.
RADIO CONTROL CODE CHANGE
With only one radio control, go directly to point 2.
With several radio controls in the same room, a new code can be created by following the
procedure below.
Disconnect the power to the hood before starting the procedure.
1) - CREATE A NEW CODE
The procedure is to be carried out on the radio control.
Press LIGHT and TIMER simultaneously until the display starts lashing.
•
Press DOWN on the radio control: saving is conirmed by three brief lashes of the
•
display. The new code cancels and replaces the previous default code.
Reconnect the hood to the electrical power supply, making sure that the
lights and motor are of.
2) - ASSOCIATING THE RADIO CONTROL WITH THE HOOD
USING THE ELECTRONIC PUSHBUTTON PANEL
press TIMER ( ) on the hood pushbutton panel for 2 seconds:
the red LED lights up.
press any key on the radio control within 10 seconds.
UP
Motor switch-on and speed increase from 1
to 4. Speed 4 is only active for a few minutes.
DOWN
Speed decrease and motor switch-of.
Light ON-OFF
TIMER ON: The motor automatically switch-
es of after 15 min.
The function is automatically disabled if the
motor is switched of ( key)
Command transmission active
) again until all LEDs are lit up.
RESTORING DEFAULT CODE
the procedure is to be carried out if the hood is disposed of, sold or transferred.
Disconnect the power to the hood before starting the procedure.
Press UP and DOWN simultaneously on the radio control for more than 5 sec-
•
onds: reset is conirmed by three brief lashes of the display.
Reconnect the hood to the electrical power supply.
•
Proceed with associating the hood and the radio control, as described in point 2.
•
19