_Origo_1500_3000_6000.book Seite 15 Freitag, 29. Januar 2010 4:09 16
Dometic ORIGO
The manufacturer recommends the use of gimbals to mount ORIGO 1500 or
3000 (accessory). Mount the gimbals as follows:
Fasten the gimbal sideplates (1) to the lower body of the stove (3) using
the enclosed nuts and bolts.
Note
I
The gimbal arms (2) can be turned to enable the stove (3) to be
lowered forwards or backwards.
Before mounting the gimbal arms (2), make a test by attaching them to
the gimbal sideplates (1) in order to determine which alternative is right
for your boat.
Remember, when the gimbals are in down position, the stovetop must be
raised to full upright position in order to remove the fuel canisters for fill-
ing.
Ensure the installation is done according to fig. 5, page 4.
Place the fibre washers (4) with round holes on the gimbal arms (2).
Lift the stove into position.
Place the fibre washers (5) with oblong holes on the gimbal sidearms (2).
Fasten the screws (6).
Adjust the tension of the screws to the desired friction.
Place a class B-1 fire extinguisher in reaching distance.
Mounting the stove
15