Mounting The Stove - Dometic ORIGO 1500 Notice D'utilisation

_Origo_1500_3000_6000.book Seite 14 Freitag, 29. Januar 2010 4:09 16

Mounting the stove

7 Mounting the stove
You can fit the stove (1500/3000) into the countertop of your kitchen. Place
Origo 6000 – 6200 into your kitchen.
7.1 Selecting the installation location
When selecting the installation location, observe the following instructions:
Select a well-ventilated location for the device.
Avoid draft at the installation location.
If you fit the stove in an open cockpit or other open areas mount an
additional wind protection.
Do not operate the device in spaces where danger of explosion is
present.
Leave a clearance of at least 50 mm to the side walls and 750 mm to
uninsulated surface above the stove.
If gimbals are used (accessory for 1500 and 3000), ensure that the stove
can swing freely.
6000, 6200: Leave at least 100 mm to the back wall and 750 mm to
uninsulated surface above the oven.
6000, 6200: Ensure you have ample room to swing the gimballed range.
7.2 Installing the stove (fig. 5, page 4)
Caution – Danger of damaging the device!
a
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
If you don't use gimbals, mount the stove as follows:
Drill through the markings in the stove bottom.
Fasten the stove through the holes in place.
14
Dometic ORIGO