Luxibel LX 301 Mode D'emploi page 4

5.3 Lamps
•
Only fit or replace a lamp when the device is unplugged from the
mains.
•
Let a lamp cool down before replacing it as the temperature of a
lamp can reach 700°C during operation.
•
When handling a halogen lamp, do not touch it with your bare
hands. Use a cloth to insert or remove it.
•
Do not install lamps with a higher wattage than what this device was
designed for.
•
Replace any deformed or damaged lamp with a lamp of the same
type (see Technical Specifications):
1. Unscrew the 2 marked screws on the side of the fixture and open the front glass cover.
2. Disconnect the wires at the screw terminals. Lift the lamp and remove.
3. Replace the lamp and close the lamp compartment.
6. Use
6.1 Detailed DMX Values per Channel
Channel Function
1 INTENSITY
2 FLASH DURATION
3 FLASH RATE
4 EFFECTS
•
INTENSITY: Set the flash intensity from minimum (blackout) up to maximum using the intensity
fader. The maximum intensity is reduced in low power mode.
•
FLASH RATE: Set the flash rate from 0 to 25 flashes per second using the flash rate fader. Switch
the flashing on and off with the run/stop button (red LED when switched on, green LED when
switched off).
•
CHASE/SYNC: The chase/sync button toggles between staggered and simultaneous flashing of
multiple fixtures. The LED blinks in chase mode and remains steady in sync mode.
•
BLINDER EFFECT: The blinder effect is controlled through the momentary blinder effect button. The
lamp power is electronically regulated to prevent the lamp from overheating.
•
SINGLE FLASH: Press the single flash button to select the single flash mode with continuous
flashing stopped. The flash rate cycle can be restarted by pressing the single flash button while
continuous flashing is running.
V. 01 – 08/06/2012
LX301
From To Description
0 5 Blackout
6 255 Intensity from 0 ~ 100%
0 255 From 0 ~ 530ms
0 5 No rate
6 255 From 0.6 ~ 30Hz
0 5 No effect
6 42 Ramp up
43 85 Ramp down
86 128 Ramp up-down
129 171 Random
172 214 Lighting
215 255 Spikes
4 ©Velleman nv