Clock And Date Adjustment; Connecting The Cuff To The Monitor - AEG BMG 5611 Mode D'emploi

English
86
When the LCD shows the battery symbol
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid
relevant damage of battery leakage.
Do not let battery fluid get into your eyes. If it should get in your eyes, immedi-
ately rinse with plenty of clean water and contact a physician.
The monitor, the batteries and the cuff, must be disposed of according to local
regulations at the end of their usage.

2. CLOCK AND DATE ADJUSTMENT

a. Once you install the battery or turn off the monitor, it will enter Clock Mode, and
LCD will display time and date by turns. See Fig. 2 & 2-1.
Fig. 2
b. While the monitor is in Clock Mode, pressing the "START" button and the "MEM"
button simultaneously; a beep is heard and the month will flash first. See Fig. 2-2.
Press the button "START" repeatedly; the day, the hour and the minute will flash in
turn. While a number is flashing, press the button "MEM" to increase the number.
Hold the button "MEM" depressed, the number will increase rapidly.
c. You can turn off the monitor by pressing the "START" button when the minutes are
flashing, then the time and the date are confirmed.
d. The monitor will turn off automatically after 1 minute of no operation; with the time
and date unchanged.
e. After replacing the batteries, you should set the time and the date again.

3. CONNECTING THE CUFF TO THE MONITOR

Insert the cuff tubing connector into the socket in the left side
of the monitor. Make certain that the connector is completely
inserted to avoid air leakage during blood pressure
measurements.
Avoid compression or restriction of the connection tubing during measurement, as
this may cause an inflation error or harmful injury due to continuous cuff pressure.
, replace all batteries with new ones.
Fig. 2-1 Fig. 2-2