Makita SD100D Manuel D'instruction page 8

1
► 1. Blade cap 2. Hook
During operation, insert the blade cap to the hook on
the base as illustrated until it clicks.
1
► 1. Blade cap 2. Hook
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1. Hex wrench
Connecting a vacuum cleaner
CAUTION:
Attach the blade cap before con-
necting vacuum cleaner.
Connect a Makita vacuum cleaner for clean operation.
Remove the rubber cap on the dust collector and con-
nect the vacuum cleaner's hose to the nozzle of the
dust collector.
2
► 1. Dust collector 2. Rubber cap 3. Vacuum cleaner
hose
OPERATION
CAUTION:
CAUTION:
the workpiece during cutting. Never perform a
curved cut. Failure to do so may cause blade break-
age, resulting in a serious injury.
The V-notch and convexed portion in the base cover of
the tool indicate the position of the blade. Always check
2
the blade position when cutting.
The base cover of the tool
1
► 1. V-notch 2. Convexed portion 3. Blade
NOTE: For accurate cutting, it is recommended to
draw cutting lines on the workpiece beforehand.
1.
tool so that the front edge of the base touches the work-
piece. Align the bottom of the V-notch in the front edge
with the cutting line.
8 ENGLISH
1
Hold the tool firmly.
Always hold the base flush with
1
2
3
Place the tip of the blade on the start line. Tilt the
2
3