Skil IF5940-00 Guide D'utilisation page 15

Use the Digital Pressure Gauge in the
High-Volume Mode (Fig .12)
1. Attach the battery pack onto the dual
function inflator or connect the 12V d.c.
vehicle connector to your vehicle's 12V d.c.
accessory socket.
2. Turn the digital pressure gauge on by
pushing the power button. The working
mode will default to the high-pressure mode
. Press the mode button
to the high-volume mode
3. To start or pause the inflation or deflation,
press the start/pause button. Note: because
the target pressure cannot be set in the high-
volume mode, there is no pressure-related
automatic shut-off.
CAUTION
CAUTION
NOTE: The dual function inflator will shut down after 5 minutes of inactivity.
LED Work Lights
Three LED work lights are located in the left side of the dual function inflator. To turn the LED
work lights on, first power on the dual function inflator by pressing the power button, then
press the LED On/Off Button. Press the LED On/Off button again to turn off the LED work
lights.
.
Allow the dual function inflator to cool for 5minutes after each 15 minutes
of continuous use.
The dual function inflator will not shut off automatically when it is working
in the high-volume mode.
Fig. 12
to switch
15