Polar Bear BRC Série Mode D'emploi page 30

Ø 500 mm fans (BDC)
Installation of single row motor models
HORIZONTAL AIR DISCHARGE
1
Fasten model by means of lifting
brackets.
3
Position unit as to obtain the desi-
red configuration.
5
Transfer model to installation site,
secure it with adequate screws and
remove the brackets that were
used for hauling.
VERTICAL AIR DISCHARGE
1
Fasten model by means of lifting
brackets.
3
Transfer model to installation site,
secure it with adequate screws and
remove the brackets that were
used for hauling.
EN BRC / BRE / i-BRE / BDC / i-BDC
30
2
Place it on two wooden boards and
replace the lifting brackets with the
ones supplied loose with model.
4
Replace the brackets used for posi-
tioning with those supplied for
installation.
6
Remove immediately protective
film (LDPE) from casing.
2
Lift model and mount the support
legs supplied loose with model.
4
Remove immediately protective
film (LDPE) from casing.
Ø 630 mm fans (BDC, i-BDC)
Installation of single row motor models
HORIZONTAL AIR DISCHARGE
1
Remove top , side panels and front
and back panels of package, secu-
re model to lifting brackets and lift
model.
3
Transfer model to installation site,
secure it with adequate screws and
remove the brackets that were
used for hauling.
VERTICAL AIR DISCHARGE
1
Remove top , side panels and front
and back panels of package, secu-
re model to lifting brackets and lift
model.
3
Replace the lifting brackets with
those supplied loose with model.
5
Transfer model to installation site,
secure it with adequate screws and
remove the brackets that were
used for hauling.
2
Remove base of package and
mount base support brackets sup-
plied loose with model.
4
Remove immediately protective
film (LDPE) from casing.
2
Place it on two wooden boards and
position the model in the desired
configuration.
4
Fasten model to the new brackets,
lift and mount the support legs sup-
plied loose with model.
6
Remove immediately protective
film (LDPE) from casing.