Intertek TENZO XXPB2-CR Manuel D'installation page 6

STEP #3
A ~ M
AKE A SILICONE JOINT AROUND THE VALVE BOX TO PREVENT WATER INFILTRATION IN THE
. I
WALL NSTALL THE STEEL PLATE ON THE VALVE
.
BETWEEN THE PLATE AND THE SILICONE
~
B I (
NSTALL THE DIVERTER HANDLE TOP HANDLE
( ). T
BOTTOM HANDLE IGHTEN THE SETSCREWS AND ADD THE SCREW CAPS
ÉTAPE #3
A ~ M
ETTRE UN JOINT DE SILICONE AUTOUR DU BOÎTIER AFIN D
. I
PÉNÉTRER DANS LE MUR NSTALLER LA PLAQUE DE FINITION SUR LA VALVE
'
FERMEMENT AFIN D ASSURER LE CONTACT DU SILICONE AVEC LA PLAQUE
B ~ I
NSTALLER LA POIGNÉE DE LA VALVE DÉVIATRICE
(
POIGNÉE DE LA VALVE PRESSION BALANCÉE POIGNÉE DU BAS
- .
PRESSION ET AJOUTER LES CACHE VIS
MI-XXPB2-XXPB3
. P
RESS FIRMLY TO ENSURE PROPER CONTACT
). I
NSTALL THE PRESSURE BALANCE HANDLE
.
' '
EMPÊCHER L EAU DE
. A
PPUYEZ
.
( ). I
POIGNÉE DU HAUT NSTALLER LA
). V
ISSER FERMEMENT LES VIS DE
Rev_21/06/2017
11
T
ROUBLESHOOTING
Problem
Water too hot or too cold
Supply of hot and cold water lines are
reversed.
Low pressure
1 - Water hose pinched or squeezed from
behind.
2 - Water pressure inferior to 35 psi.
The rain shower head continuously drips after use
1 - The rain shower head is placed
horizontally.
2 - The cartridge of the shower head does
not close properly.
Water temperature too hot or too cold at the twelve o'clock position
1 - The temperature of your water heater is
not adjusted to 60 ° C (140 ° F).
2 - Temperature handle is in the wrong
position.
Change in temperature
1 – Pressure lower than 35 psi.
2 -Water line overloaded.
MI-XXPB2-XXPB3
Solution
Interchange the water supply hoses.
Make sure that the hoses are well positioned
and are not pinched or squeezed anywhere.
A - Water supply from the city;
No possible solution
B - Water supplied by well;
Increase the pressure of your pump.
Place your rain shower head at an angle to
allow the water to drain.
Remove handle, unscrew the cartridge and
ensure that there is no debris.
Make the adjustment of the temperature of
your water heater.
Remove the handle, adjust the position of
the cartridge and put the handle back on.
No solution possible.
Feed directly into the main supply.
Rev_21/06/2017
12