Publicité
Les langues disponibles
Les langues disponibles
Burst of Steam
Just as with the Spray function you can also get an additional burst of steam when ironing with or without steam by doing the following:
•
Set the temperature regulator between the (••) and (•••) Max settings and wait until the iron reaches temperature.
•
Raise the iron slightly up off the material and press the super steam button down firmly.
•
Pause for at least 5 seconds between each jet of steam.
Crease removal in vertical
• Set the temperature regulator between the (••) and (•••) settings and wait until the iron reaches temperature.
• Hang the garment on a hanger and place the iron some 10-20 cm away. Never iron a garment if somebody is wearing it at the time.
• Press the super steam push button pausing for at least 5 seconds between each press.
Anti-Calc System
This iron has an innovative built-in anti-limescale system, consisting of a resin filter that retains the limescale substances from the water, so these
cannot reach the steam chamber of the soleplate, thus extending the life of the iron.
However, please note that the anti-limescale cartridge will not completely stop the natural process of limescale build-up.
Anti-Drip system
The iron incorporates an anti-drip system that prevents the iron from dripping, even when it is switched off.
•
With the anti-dripping system, you can perfectly iron even the most delicate fabrics.
Self-Cleaning
The function of self clean is to clean the soleplate after using the iron for approximately 2 months.
1. Fill the water container up to the marking MAX.
2. Insert the plug into the power socket.
Instructions for use
English
5
Publicité
