Christopeit Sport BS 2 Notice De Montage Et D'utilisation page 19

Step 3:
Attach the front post (12) at main frame (1).
1. Push the support cover (11) onto handlebar support (12).
2. Hold the handlebar support (12) with the computer cable (3) against the
main frame (1) and connect the plug for the computer cable (3) coming
out of the bottom of the handlebar support (12) of the computer with
the matching plug for the motor cable (16) coming out of the main frame
(1).
3. Place the handlebar support (12) in the locator provided for it in the main
frame (1). Ensure that the cable connections are not squashed, when
putting the steering tube in place, push the former slowly down into the
locator in the main frame. Screw the handlebar support (12) onto the
base frame (1) with the screws (14), spring washers (15) and washers
(13).
4. Push the handlebar support cover (11) into right position to cover up
the screw connection point.
Step 4:
Attach the saddle (34) and saddle support (29).
1. Push the saddle (34) with saddle bracket (38) into the saddle slide (33)
and tight it up in desired position.
2. Place the saddle slide (33) into the holder of saddle support (29), set
it at the desired position and screw it onto the saddle support (29) by
screw (6) washer (32) and star grip nut (31).
3. Push the saddle support tube (29) into the matching locator in the main
frame (1), set it at the desired position and lock it by inserting the bolt
with the quick release (30) in place and doing it up tight.
(The setting of the saddle support can be adjusted easily as desired later
through turning and pulling the quick release (30).) Furthermore, you must
ensure when setting this desired position that the saddle support is not
pulled out of the main frame further than the highest setting position,
which is marked.
Attention: Ensure before every exercising that the saddle is tighten
firmly
19