Muse M-196 TL Manuel De L'utilisateur page 8

GB CAR RADIO WITH BLUETOOTH & USB/ MICRO SD
PRECAUTIONS
1. Do not attempt to modify the unit, modifying the unit may cause an accident.
2. Installation or servicing of the unit by persons without training and experience in electronic
equipment and automotive accessories may be dangerous and could expose you to the risk of
electric shock or other hazards.
3. Stop the vehicle before carrying out any operation that could interfere with your driving.
4. Keep the volume at a level which you could hear sounds from outside the vehicle.
5. Do not work in extremely high or low temperature. Be sure the temperature inside the vehicle is
between +60°C and -10°C before turning on your unit.
6. When replacing the fuse(s), the replacement must be of the same amperage as shown on the
fuse holder.
7. Do not block vents or radiator panels. Blocking them will cause heat to build up inside and may
result in fire.
8. Using this unit without running the engine can result in battery drainage.
9. Use only in cars with a 12 volt negative ground.
10. After completing the installation or replacing the car battery, you need to RESET the unit before
using it. Press RES button on the front panel with pointed object (such as ball-point pen) to reset
the unit to its initial settings.
Reset
UNPACK YOUR UNIT
When you unpack your new car radio, make sure that you have removed all the accessories and
information papers:
Main unit
User manual
Accessories:
AR-3838A IB MUSE 001 REV0.indd 8
GB - 1
CONNECTION
Caution!
- Make sure to connect the color coded leads according to the diagram. Incorrect connections may
cause the unit to malfunction or damage the vehicle's electrical system.
- Make sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect the left and right
channel speaker cables each other or to the vehicle body.
- Make sure all the connections are completely correct before turning on your unit.
Do not connect the ignition wire (red) and the battery wire (yellow), it may cause a short
circuit, even result in fire.
INSTALLATION
The unit is installed to be an anti-theft one. The chassis of the unit wears a sliding metal housing.
Please do the connection of the power. Speakers and antenna are according to the requirement of the
instruction book. Then install
the sliding metal housing in the
car as follows:
GB - 2
2018/8/31 10:14:24