Technical Data; Technical Description - Nordica FULVIA Manuel Utilisateur

TECHNICAL DATA

Definition in accordance with EN
Constructive system
Nominal power in kW
Efficiency in %
smoke outlet diameter in mm
Chimney height ≥ (m) - dimension (mm)
Chimney draught in Pa (mm H
Hourly wood consumption in kg / h (wood with 20% humidity)
CO measured at 13% oxygen in %
Exhaust gas emission in g/s – wood
Exhaust gas temperature in °C - wood
Hearth opening size in mm (W x H)
Hearth size in mm (W x H x D)
Oven size in mm (W x H x D)
Type of grill
Height in mm
Width in mm
Depth in mm
Weight in kg
Fire prevention safety distances
heatable m
(30 kcal/h x m
3
(*) The proposed value are indicative. The installation must, in any case, be sized and verified according to the general calculation method in UNI
EN13384-1 or by another method of proven efficiency.
(**) For those buildings in which the thermal insulation does not correspond to the instructions on heat protection, the heating volume of the
product is: favourable type of building (30 kcal/h x m
x m ).
3
With thermal insulation in accordance with the regulations regarding energy saving, the heated volume is greater. With temporary heating, in
the event of interruptions which last more than 8 hours, the heating capacity is reduced by about 25%.
The declared technical data have been achieved by burning beech wood class "A1" according to the requirement UNI EN ISO 17225-5 and wood
moisture content less than 20%. By burning a different kind of wood the efficiency of the product itself could change and some specific adjustments
on the appliance could be needed.

TECHNICAL DEsCRIPTION

The chimney stoves of La NORDICA are suitable to heat living spaces for some periods. As fuel, wood logs are used. The appliance works as
an intermittent operating appliance.
The stove is made of sheets of metal in galvanized steel, enamelled cast iron and, depending on the model, thermo radiant ceramics or
soapstones.
The hearth is internally sheathed with single sheets in cast iron and inside it there is a turning and extractable grate; the back side is extractable.
Thanks to some calibrated holes made over that side, the supply of pre-heated air inside hearth is guaranteed and having, in this way, a post-
combustion which increases the yield and reduces gas output. Inside it there is a turning and extractable grate.
The hearth is equipped with a panoramic door with ceramic glass (resistant up to 700 °C). This allows a wonderful view on the burning flames.
Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth door will be found an extractable ash-drawer with a closing door
ACCEssORIEs
GAIA
GAIA Forno
FULVIA
FULVIA Forno
The heating of the environment is made by:
• Convection: (70%) the air passage through the double mantel of the stove releases heat into the environment;
• Irradiation (30%): through the panoramic glass and the external hot surfaces of the stove, the heat is radiated into the environment.
( see chapter CALCULATION OF THE THERMAL POWER).
O)
2
)
3
); less favourable type of building (40 kcal/h x m
3
POKER
sERIEs
sERIEs
sERIEs
sERIEs
FULVIA
EN 13240
1
6
82
120
1,7
0,06 - 750 mg/m 0,06 - 750 mg/m
3
6
242
210 x 255
273 x 370 x 320 273 x 370 x 320
/ 227 x 296 x 290
862
488
477
172 (**)
(Picture 8 -
GLOVE
sERIEs
sERIEs
sERIEs
sERIEs
ENgLIsH
FULVIA
gAIA
Forno
EN 13240 EN 13240
1 1
6 6
82 82
120 120
(*) 4 - 200x200 Ø200
12 ( 1,2 mm H O)
2
1,7 1,7
0,06 - 750 mg/m
3
6 6
242 242
210 x 255 210 x 255
273 x 370 x 300
/
Movable - flat
1288 906
488 495
477 468
Chapter FIRE sAFETY
172 (**) 172 (**)
); unfavourable type of building (50 kcal/h
3
B).
gAIA
Forno
EN 13240
1
6
82
120
1,7
0,06 - 750 mg/m
3 3
6
242
210 x 255
273 x 370 x 300
227 x 296 x 290
1331
495
468
172 (**)
23