Using The Plate Warmer; Drying System; Overfill Protection Float - Whirlpool Roper RUD6000 Guide D'utilisation Et D'entretien

Delay Hours
Use Delay Hours to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
To delay the start
1. Close the door.
2. Select a wash cycle and option(s).
3. Turn the cycle control knob clockwise to the number of hours
you want the dishwasher to delay the start.
NOTES:
To cancel the delay, turn the cycle control knob to the desired
cycle.
Rinse Only and the Normal Wash cycles cannot be delayed.

Using the Plate Warmer

Use the Plate Warmer cycle to warm serving dishes or dinner
plates.
NOTE: Do not use the Energy Saver Dry option.
1. Close and latch the door.
2. Turn the cycle control knob to Plate Warmer.
3. Allow 8 minutes for the cycle to heat the dishware.
4. Turn the cycle control knob to Off.
12

Drying System

During drying, you can see steam escaping through the vent at
the upper left corner of the door. This is normal as the heat dries
your dishes.
IMPORTANT: The vapor is hot. Do not touch the vent
during drying.

Overfill Protection Float

The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.
Check under the float for objects that may keep the protector
from moving up or down.