Table des Matières
Publicité
Installation
Attach the display mount to a wall
Warning! Wall structures vary, and it is important that you make sure that the type
of structure and mounting hardware that you are using will properly support the
mounted equipment. Failure to do so may result in personal injury and/or equipment
damage. The wall structure should be capable of supporting at least four times the
weight of the mounted equipment.
Warning! The mounting hardware included with this product might not be adequate
for some wall structures. If you lack the necessary expertise to attach this product to
the wall that you are using, contact a construction professional to install the ARMWALL
or to provide specific mounting instructions for your wall structure.
1. Use a Phillips screwdriver to remove the screw from the top of the display mount.
Tip! Make sure you put the screw in a safe place because you will need it when you
reassemble the mounting plate and the display mount.
2. Remove the mounting plate from the bottom of the display mount. (figure 1)
figure 1
Screw
Display mount
Mounting plate
Instruction manual
5
Publicité
Table des Matières
