JVC KD-X350BTS Manuel D'instructions page 39

TROUBLESHOOTING
Symptom Remedy
"CHECK ANTENNA" Check that the antenna and its connection are in good
condition.
"CHECK TUNER" Make sure the SiriusXM Vehicle Tuner is connected to the
unit.
"NO SIGNAL" Make sure the antenna is mounted outside the vehicle.
"SUBSCRIPTION UPDATED Your subscription is updated. Press the volume knob to
– PRESS ENTER TO continue.
CONTINUE."
"CODE ERROR" Make sure you have entered the correct pass code. ( 14)
"NO CONTENT" There is insufficient content to start TuneScan.
"SCAN CANCEL" TuneScan has been aborted.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 15)
Echo or noise occurs. • Adjust the microphone unit's position. ( 15)
• Check the [ECHO CANCEL] setting. ( 17)
Phone sound quality • Reduce the distance between the unit and the Bluetooth
is poor device.
• Move the car to a place where you can get a better signal
reception.
Symptom Remedy
Sound is being interrupted • Reduce the distance between the unit and the Bluetooth
or skipped during playback audio player.
of a Bluetooth audio • Turn off, then turn on the unit and try to connect again.
player. • Other Bluetooth devices might be trying to connect to
the unit.
The connected Bluetooth • Check whether the connected Bluetooth audio player
supports Audio/Video Remote Control Profile (AVRCP).
audio player cannot be
controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the
unit, then connect the device again.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"ERROR" Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"H/W ERROR" Reset the unit and try the operation again. If "H/W
ERROR" appears again, consult your nearest service
center.
"SWITCHING NG" The connected phones might not support phone
switching feature.
If you have any troubles, try the following:
1
Check TROUBLESHOOTING
2
Reset the unit ( 3)
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: <http://www.jvc.com>
35
ENGLISH