Publicité
Les langues disponibles
Les langues disponibles
English
1.
To fix the tool holder on the machine, insert the shank
in the tool post and fasten the two screws [1]. Rotate
the head to get acces to both screws [2].
1
2.
Calculate the angle for the work piece you want to
produce.
tan �� =
3.
Adjust the angle of the tool holder and block it with the
two rear screws [3], then fasten the two front screws
[4].
3
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
GSW161
2
2��
��(�� + ��
)
��
4
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation: 27.04.2017
4.
To mount the whirling head on the tool holder, place the
supplied special key [5] at the back of the broach, then
insert the head by slipping on the three lugs [6] in the
notches . Turn the whirling head unclockwise until stop
(you must feel the indexing balls setting up).
5
5.
Keep the special key in position and use the supplied
torque screwdriver to fasten the three Torx screws
passing through the holes [7].
Fastening torque = 2Nm
ATTENTION : always make sure that these three torx
screws are well fastened before using the tool holder!
7
Document:
GSW161 Mode
d'emploi
Page: 2 de 3
6
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Publicité
