Warmer Zone; Warm & Hold Feature - Kenmore 790.4540 Série Manuel D'utilisation Et D'entretien

Setting Surface Controls
Warm & Ready Zone
TM
The warmer zone is located at the center rear element
position on the cooktop as shown. The purpose of the
warmer zone is to maintain hot cooked foods at serving
temperature.
Use the warmer zone feature to keep cooked foods hot such
as: vegetables, gravies, casseroles, soups, stews, breads,
pastries and oven-safe dinner plates.
Do not heat cold food with the warmer zone. Always start
with hot food. All cookware placed on the warmer zone
should be covered with a lid to maintain food quality.
To Operate the Warmer Zone:
1. Place cookware with hot food on warmer zone.
2. Touch and hold the
power indicator light will turn ON. Note: If no key pad
is touched within 10 seconds the request to Power ON
the cooktop will clear.
3. Touch pad for the warmer zone until a beep is heard.
The display will show "0". Note: If no further pads are
touched within 10 seconds the request to power the
element ON will clear.
4. To set heat level press Level 1 or Level 2 keypad to adjust
to the desired power level setting. Release keypad when
desired heat level is displayed by the indicator lights.
5. When ready to serve, touch the
the element OFF and if no other surface element is used
touch the key pad to turn off the cooktop. Note: The
H (hot element) message will remain ON if the cooktop is
still hot and will remain ON until the heating surface area
has cooled suffi ciently.
Unlike other radiant surface elements, the
warmer zone will not glow red when it is HOT. The glass
surface may still be hot and burns can occur if the glass
surface is touched before it has cooled suffi ciently.
Always use potholders or oven mitts when
removing food from the warmer zone as cookware and
plates will be hot.
pad until a beep sounds. The
pad once to turn
Do not place aluminum foil, plastic items
such as salt and pepper shakers, spoon holders or plastic
wrappings on top of the range when it is in use. These
items could melt or ignite. Potholders, towels or wooden
spoons could catch fi re if placed too close to the surface
elements.
Important notes:
• For best results, when warming pastries or breads, any
covering used should have an opening to allow moisture
to escape. Use only cookware and utensils recommended
for oven and cooktop use on the warmer zone.
• The warmer zone heat level may be adjusted at any time
when the warmer zone is turned ON.
• Use only plates, utensils and cookware recommended for
oven and ceramic cooktop use. Do not use plastic wrap
or aluminum foil to cover food. Plastic or aluminum foil
can melt onto the cooktop.
Warm & Hold Feature
The Warm & Hold feature may be used with any of the
Cooking Elements (except the warmer zone).
To Turn the Warm & Hold Feature ON:
1. To select the Warm & Hold feature for any Cooking
Element touch the
Cooking Element.
2. Touch the key pad located in the main control area.
The associated display will show L (low heat) indicating
that the Cooking Element is properly set to Warm & Hold.
If no other key pads are pressed the control will activate
the desired Cooking Element at the Warm & Hold setting.
Note: The Warm & Hold feature will activate on the Cooking
Element which was set last.
11
key pad for the corresponding