Installation And Use; Cleaning And Maintenance; Safety Instructions - Casselin CCR40EP Mode D'emploi

Masquer les pouces Voir aussi pour CCR40EP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.2 Installation and use

WARNING
Installation and maintenance must be only carried out by qualified technician.
Never let your appliance operating without supervision.
Always operate with dry hands.
Operating never move or tilt your appliance.
OPERATING INSTRUCTIONS
STARTUP
Remove all protective foils and packaging material prior to usage.
Place the appliance on a flat, solid, and heat-resistant surface, on its vertical position. Never install your
appliance on inflammable surface.
Do not install the appliance near open fireplaces or all hot sources.
Do not place the appliance near inflammable material.
The plug and the cable must be protected by a circuit breaker of 16 A. Connect the appliance directly to a wall
plug socket. The use of adaptors, multiple sockets and/or extensions is not recommended.
Prior first use let the appliance in function until all smokes and bad odours disappear.
Then put the appliance off, let it cool down and rinse it thoroughly with hot soapy water with a gentle humid
cloth. Never use cold water on hot plates that could lead to a thermic chock.
USER INSTRUCTIONS
Plug your appliance and put the knob on/off, the red light goes on.
Turn the temperature knob and the green light goes on. Temperature must be between 60° and 300°C. We
recommended to use the appliance with the temperature fixed on 250°C
It takes 10 minutes to reach the 250°C temperature.
Once reached the desired temperature the green light goes off.
When the temperature goes down the appliance goes on warming and the green light goes on.
The plate do not need special operation before first use.
ADVICE
Your appliance is provided with an overheating protection. When this protection has been activated you must
let your appliance cool down.
If overheating protection is stated regularly, contact your dealer or our after-sales service.
To reset the appliance, press the reset button located on the back side of the appliance. You must unscrew
the plastic protection (counterclockwise), press the reset button and replace the plastic protection (clockwise).

6. CLEANING AND MAINTENANCE

6.1 Safety instructions

Before servicing (clean, maintenance, repair) unplug the appliance
Caustic detergents, sodium bicarbonate are forbidden for the cleaning of your appliance.
Check regularly the power cord.
Never dip your appliance in liquid.
WARNING
Not direct washing via water jets. (Neither jet under pressure)
14

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ccc40epCcd40ep

Table des Matières