Remove Access Panel; Connect Elbow To Valve; Connect Fill Hose To Elbow - Whirlpool W11160365C Instructions D'installation

REMOVE ACCESS PANEL

8.
Remove access panel
Using a 1/4" nut driver or Phillips screwdriver, remove the two
screws attaching access panel to dishwasher.
9.
Measure cabinet opening
Measure the height of cabinet opening from the underside of
the countertop to the floor where dishwasher will be installed.
Be sure to measure the lowest point on the underside of the
countertop and the highest point on the floor.
10.
Leveling leg adjustment
Extend leveling legs out from the dishwasher base, 1/4" less than
the shortest opening height measured in cabinet opening.
Turn leg counter clockwise to raise the dishwasher or clockwise
to lower the diswasher.

CONNECT ELBOW TO VALVE

11.
Connect elbow to fill valve
Tighten elbow until snug, and be sure that it faces toward
channel in bottom of base.
12.
Fill valve location
Fill valve location

CONNECT FILL HOSE TO ELBOW

13.
Flexible line
Flexible braided line: Confirm the flexible braided line is long
enough.
Attach flexible line to elbow then route hose out the bottom left
channel under the dishwasher. Secure in channel with tape or
wire ties.
Elbow
11