Installation; Fitting/Exchanging The Lamp - Futurelight SC-380 Mode D'emploi

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

Installation

Fitting/Exchanging the lamp

DANGER!
Install the lamp with the device switched off only.
Unplug from mains before!
Screws X and Y
To insert the lamp MSD/HSD 250, MSD 250/2 OR MSD/HSD 200 open the small cover at the rearpanel (see
the drawing) by loosening the 2 Phillips screws X and Y on the cover.
Gently pull out the lamp assemby.
If changing the lamp, remove the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not
designed for.
Damages caused by non-observance are not subject to warranty. Please follow the lamp manufacturer's
notes!
Do not touch the glass-bulb bare-handed during the installation! Make sure that the lamp is installed tightly
into the lampholder system.
Reinsert the lamp assembly and tighten the 2 screws again.
Do not operate the fixture with opened housing-cover!
Lamp adjustment
21