AEG FAVORIT 78420 VI0 Notice D'utilisation page 27

You must adjust the water soft-
ener manually and electronically.
Manual adjustment
Electronic adjustment
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time,
buttons (4) and (5) until the indicators
of buttons (3), (4) and (5) start to flash.
3. Press button (3).
• The indicators of buttons (4) and (5)
go off.
• The indicator of button (3) contin-
ues to flash.
6.2 Filling the salt container
Turn the water hardness dial to the posi-
tion 1 or 2.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
• The display shows the current set-
ting of the water softener, e.g.
= level 5.
4. Press button (3) again and again to
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
ENGLISH
27