Options - AEG FAVORIT 67032 VI0P Notice D'utilisation

1) The pressure and the temperature of the water, the variations of the mains supply, the
options and the quantity of dishes can change the values.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

5. OPTIONS

Activate or deactivate the op-
tions before the start of a pro-
gramme. You cannot activate or
deactivate the options while a
programme operates.
If one or more options are set,
make sure that the related indi-
cators are on before the pro-
gramme starts.
5.1 ExtraHygiene
With this option you have better hygiene
results. During the rinsing phase, the
temperature stays at 70 °C for at least 10
minutes.
How to activate the ExtraHygiene
option
1. Press ExtraHygiene. The related in-
dicator comes on. In the display you
can see the update of the pro-
gramme duration.
• If the option is not applicable to
the programme, the related indica-
tor flashes quickly 3 times and then
goes off.
5.2 Multitab
Activate this option only when you use
the combi detergent tablets.
This option deactivates the use of rinse
aid and salt. The related indicators stay
off.
The programme duration can increase.
How to activate the Multitab option
1. Press Multitab, the related indicator
comes on.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the wa-
ter hardness in your area.
5. Adjust the released quantity of rinse
aid.
5.3 Acoustic signals
The acoustic signals operate when the
appliance has a malfunction, when the
adjustment of the level of the water soft-
ener occurs and when the programme is
completed.
By default, the acoustic signals are on,
but it is possible to deactivate them.
How to deactivate the acoustic signals
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time but-
tons (4) and (5) until the indicators of
buttons (3), (4), (5) and (6) start to
flash.
3. Press button (5).
• The indicators of buttons (3), (4)
and (6) go off.
• The indicator of button (5) contin-
ues to flash.
• The display shows the current set-
ting.
Acoustic signal on.
ENGLISH
59