Publicité
OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
NOTES
• When the spotlight is properly connected to the mains, "Software Update Please Wait" (only for internal purposes), "Welcome to Cameo", the model
name and software version appear successively on the display during the start-up process. After this operation, the spotlight is ready for use and
starts in the mode that was previously selected.
• If the DMX operating mode is activated and there is no DMX signal at the DMX input, the display starts to flash after a few seconds.
• After approximately 30 seconds of inactivity, the display will automatically show the currently active operating mode.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure which allows menu and sub-menu items
that were last selected to be accessed directly. 1. Pressing MODE and ENTER simultaneously will take you directly to the sub-menu item that was
last edited and allows you to instantly change the corresponding value as desired (DMX start address and all operating modes). 2. Pressing MODE
will take you directly to the menu item that was last selected and edited; now press ENTER to instantly access the sub-menu item that was selected
and edited last (DMX start address and all operating modes).
SETTING THE DMX START ADDRESS
Press the MODE button repeatedly until "Menu DMX Address" or "Menu Mode" appears on the display. If necessary, using the UP and DOWN buttons,
select the "Menu DMX Address" menu item and confirm with ENTER. Using the UP and DOWN buttons, select the desired DMX start address and
confirm with ENTER. At the same time, the DMX operating mode starts.
ENTER
UP/DOWN
SETTING THE OPERATING MODE (Mode)
Press the MODE button repeatedly until "Menu DMX Address" or "Menu Mode" appears on the display. If necessary, using the UP and DOWN buttons,
select the "Menu Mode" menu item and confirm with ENTER. The required DMX mode can be selected as desired by using the UP and DOWN buttons
and activated by pressing ENTER (see tables, observe the sub-menus) You will find a comprehensive DMX table in the DMX CONTROL section of this
manual.
Operating modes
Mode DMX
= DMX mode
Mode Sound
= Music control mode
Mode Slave
= Slave mode
Mode Static
= Setting a "Scene" without external controllers
ENTER
UP/DOWN
-
ENTER
/
ENTER
UP/DOWN
/
ENTER
/
ENTER
UP/DOWN
ENTER - UP/DOWN
3CH
= 3-channel mode
Sound
= Spot responds to bass impulses, Microphone sensitivity
can be adjusted (Mic Sens).
Slave
= Connect the DMX IN of the slave unit to the DMX OUT
of the master unit (same model) and activate one of the
standalone modes (Sound, Static) on the master unit. Now
the slave unit follows the master unit.
Static
= Master Dimmer, Dimmer Fine and Strobe can be adjusted
individually (strobe function as channel 3 in the 3-channel
DMX mode).
ENTER
ENTER
-
ENTER - UP/DOWN
ENTER
ENTER
-
ENTER - UP/DOWN
ENTER
15
Publicité
