Publicité
Les langues disponibles
Les langues disponibles
Position
Excess moisture will travel throughout your home, in the same way that cooking smells
waft to every room in the house. For this reason, the dehumidifier should be positioned,
so that it can draw this moist air towards it from all over the home.
Alternatively, if you have a serious problem in one area you can begin by positioning the
dehumidifier close to this area and later moving it to a more central point.
When positioning the dehumidifier, ensure that it is placed on a level surface and that
there is a minimum of 10 cm (4") of space on either side of the unit to allow for efficient
airflow.
If you move the unit, it should first be switched off and the water tank emptied.
We do not recommend the use of an extension lead, so please try to ensure that the unit
is sufficiently close to a fixed mains socket. If it is necessary to use am extension lead,
use one with earthing and please ensure the diameter of the wires of the cable is at least
1,5 mm2.
Don't place the device near a heater, stove or other heat source, and not in full sunshine.
When the dehumidifier is in operation, outside doors and windows should be closed
when necessary for most efficient use. However, do not use the device in a sealed or
very small space.
Operation
1. Turn the on / off
now
deactivated.
specifications on the rating
2. Turn the humidistat clockwise direction
compressor catch on and the device starts its
to
MAX, the lower
3. When the unit reaches the set
humidity rises above the set value, the machine will turn on again.
4. When you turn the on / off
continuously;
by turning
Press the ON / OFF button again to switch it off again.
5. After use, always remove the plug from the
Drainage
While the water tank is full, the compressor will stop for
self-protection and the water full indicator will turn into
red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank into
space. Make sure it is properly positioned, in order for
the 'water full' sign to go out and your dehumidifier is
operating.
Please note: in case, the water tank has not been
positioned well, the water full indicator will turn into red.
The equipment does not work.
button,
also
humidistat,
Plug into a earthed
label.
you set the
humidity.
humidity, it will
button completely to
te button back to
completely
to
OFF / MIN mode: the device is
mains socket, corresponding to
MAX.
At one point you will hear the
operation.
automatically stop his
MAX, the unit will operate
OFF / MIN you switch off the device.
socket.
10
the
The further you turn the knob
works; when
the
Publicité
