Dirt Devil INFINITY REBEL55 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
DD 5255.book Seite 15 Montag, 23. Februar 2015 10:48 10
4 Troubleshooting and technical data
4.1 Before you send in the appliance
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the
appliance and disconnect it from the mains before starting troubleshoot-
ing.
Before contacting us or even sending the appliance to us, use the table to
check whether you can correct the problem yourself.
Problem
Possible cause / solution
The cleaning
The bypass vent (Fig. 15) is open.
results are
Close the bypass vent (Fig. 15).
unsatisfac-
The attached nozzle is unsuitable.
tory in spite
of the appli-
Change the nozzle, Chapter 2.1, 'Assemble appliance
ance work-
and adjust nozzles to surface'.
ing correctly.
The collar brush of the floor nozzle is not in a position
appropriate to the type of floor (Figures 7 – 8).
Adjust the position of the collar brush to the type of floor
using the floor nozzle switch (Figures 7 – 8).
The dust container is full.
Empty and clean the dust container Chapter 3.1,
'Emptying and cleaning the dust container'.
The filters are dirty.
Clean the filters, Chapter 3.1, 'Emptying and cleaning
the dust container' that is Chapter 3.3, 'Cleaning /
changing the exhaust filter'.
Nozzle, telescopic tube or suction hose is blocked.
Remove the obstruction. If necessary, use a long wood-
en stick (e.g. a broomstick) to do this.
4.2 Warranty
The statutory warranty regulations in accordance with the EU Directive
1999/44/EC apply.
4.3 Disposal
Dispose of the appliance in compliance with the environmental
protection laws of your country. Electrical waste may not be dis-
posed of together with domestic waste. Use local old-appliance
collection points instead.
4.4 Technical data
Type of appliance
: bagless multi-cyclonic
vacuum cleanerr
Model name
: Infinity Rebel 55
Model
: DD5255 [-0/-1/.../-8/-9]
Voltage
: 220-240 V ~, 50/60 Hz
Power
: 800 W
Maximum usable volume of the
: approx. 2.5 litres
dust container
Power cord length
: approx. 6 m
Weight
: approx. 5.2 kg
Technical and design specifications
may be changed in the course of contin-
uous product improvement.
© Royal Appliance International GmbH
4
Troubleshooting and technical data
Problem
Possible cause / solution
Cleaning /
The dust container is full.
emptying
Empty and clean the dust container Chapter 3.1,
display lights
'Emptying and cleaning the dust container'.
up (Fig. 16).
The filters are dirty.
Clean the filters, Chapter 3.1, 'Emptying and cleaning
the dust container' or Chapter 3.3, 'Cleaning / chang-
ing the exhaust filter'.
Nozzle, telescopic tube or suction hose is blocked.
Remove the obstruction. If necessary, use a long wood-
en stick (e.g. a broomstick) to do this.
The vacuum
The overheating protection has tripped (possibly due to
cleaner
blocked suction channels, filters, or similar).
stops sud-
1. Switch the appliance off and pull the plug out of the
denly.
socket.
2. Remove the cause of overheating (e.g. by disas-
sembling telescopic tube and suction hose and re-
moving the obstacle and/or cleaning filters).
3. Wait approx. 45 minutes until the appliance has
cooled off.
4. After the appliance has cooled off, you may switch it
on again.
NOTE:
If you cannot solve the problem following these instructions, contact our
customer services (Page 46, 'International Service').
In non-EU countries the minimum requirements of the warranty in the re-
spective country apply.
The filters are made from environment-friendly materials. You can dispose
of these — as opposed to the appliance — in your domestic waste unless
you have cleaned up substances that are prohibited from disposal in this
way.
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dd 5255

Table des Matières