Description; Installation - EuroLite LED PAR-56 Spot/Floor Mode D'emploi

DESCRIPTION

Features
LED PAR Spot
DMX-512 control via regular DMX-controller (occupies 5 channels) • Sound-control via built-in microphone •
Color-change speed and strobe effect adjustable via dip switches • Locking possibility at the mounting
bracket • For illuminating e. g. mirror balls, entrance or counter areas or as basic illumination • Perfect in
public places, main halls, stages, lounges • Multi-color color-changes • Master/Slave function • Advantages
of LED-technology: extremely long life of the LEDs, low power consumption, minimal heat emission, defacto
maintenance free with brilliant light radiation • Available in alu, white or black

INSTALLATION

Overhead rigging
Overhead rigging
Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the projector. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be
used. The projector must never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
DANGER TO LIFE!
17/41 00026194.DOC, Version 1.4