EtiamPro PEM30DN Mode D'emploi page 4

• Keep the cables well clear of other current-carrying conductors in
order to avoid the creation of magnetic fields which may cause
interference.
• Do not install the sensor where it is exposed to fluorescent lamps
with rapid-starters or high-frequency starters.
• Do not expose the device to dust, water, dirt or oil and protect it
from vibrations or shocks to prevent malfunction.
3. Wiring
The black, white and grey cables are only available on the receiver.
4. Aligning transmitter with receiver
Use the LEDs to align the transmitter and the receiver. This is easiest
if you use an IR viewer.
5. Technical Specifications
detection method ..................................................... through beam
sensing range...................................................................... 30 m
input voltage
12-240 VDC ± 10 %
24-240 VAC ± 10 %
response time .................................................................... 15 ms
emitting element ............................................................... IR LED
operation indicator ................... yellow LED (lights when beam is cut)
dimensions ........................................................ 21 x 55 x 50 mm
current consumption ....................................................... 2 A max.
output method ........................................................... relay output
V. 03 – 10/06/2020
PEM30DN
4 ©Velleman nv