10. Technical information
10.1 Operating principle
The operating principle of air-air heat ex-
changers is based on the transfer of heat
between two air flows with different temper-
atures through a surface featuring a high
heat transfer coefficient (figure F.06) which
separates the two environments to avoid
the transfer of dirt and contaminants from
the exterior to the interior environment.
12. Troubleshooting
Malfunction
Conditions
No component works
Only one of the two fans
are working
It fails to cool
The fans are working
10.2 Safety devices
The fans are fitted with an internal protection
device that shuts them off in the event of
overheating.
11.Disposal
Before beginning removal of the unit,
ensure that it has had its power supply
disconnected.
Causes
No electricity getting to the
unit
Fan failed
Capacitor failed
Heat exchanger coil either
dirty or clogged
Ambient temperature over the
maximum working limit
7
The removal of this unit must be performed
by expert personnel and the competent au-
thorities.
Remedy
Check there is voltage as well as closing of doors and
switches
Change the fan
Change the capacitor
Clean the coil
Ventilate the premises where the enclosure is installed
to keep ambient temperature lower
ENG