CMT ORANGE TOOLS CMT3000 Instructions D'emploi page 6

ELLIPSE CUTTING
Minor semi-axis setting
(Fig. 7) Rotate the router by 90°. The cross frame (1) must not be rotated! The complete slider (B)
is at the centre of the cross frame). Set the required minor semi-axis length by moving the extension
(4) and (5) in the slider pin (B); the complete slider (A) remains tightened. Once the minor semi-
axis has been set, tighten the bolt (7) of the complete slider (B).
Fig. 7
Attention: If the work piece is bent or warped, the complete sliders (A) and (B) may block in the
slots of the cross frame (1), so only perfectly flat material must be used.
Major axis L1
3000
2000
1800
1700
1500*
1400
1300
1200
1100
1030
900
800
730
Min/Max radius routing with standard equipment
6
A
Shorter axis L2
MIN
2590
1590
1390
1290
1090
990
890
790
690
620
620
620
620
B
MAX
2890
1890
1690
1590
1390
1290
1190
1090
990
920
790
690
620
www.cmtorangetools.com
B
A