CMT ORANGE TOOLS CMT3000 Instructions D'emploi page 4

CIRCLE CUTTING
CIRCLE CUTTING
(Fig. 2) Draw the 90° axes of the circle to be cut on the work piece. (Fig. 4) Fix the cross frame (1)
to the work piece (Fig. 4) using the wood screws (13) or with double-sided adhesive tape so that
the grooves of the cross frame coincide perfectly with the previously individuate axes (Fig. 3).
The cross frame is now centered on the circle's axis.
(Fig. 5) Fit the complete slider (A) into the cross frame slot, move it towards the centre of the cross
frame, (1) where the slots cross, and fix it to the structure (1) using the two countersunk screws
M4x25 (14). Move the router along the extension rods (4) e (5) until the radius is set and once this
has been done, tighten the bolt (7) on the slider pin (2).
NB: Diameters of between 620 and 3000 mm can be cut
90°
Fig. 2
Fig. 3
13
14
A
Fig. 4
Fig. 5
www.cmtorangetools.com
4