User Manual - Toolland TL73102 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland. Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Always wear protective gloves.
Warning: risk of property damage or bodily injury.
• Always respect the safety instructions.
All persons not involved in the loading process must stand clear of the loading ramp.
•
Avoid working alone. If an accident happens, an assistant can bring help.
•
Keep work area well lighted.
•
Dress properly. Do not wear loose clothing or jewellery as they can be caught in moving parts. Protective,
•
electrically non conductive clothes and non skid footwear are recommended when working. Wear restrictive
hair covering to contain long hair.
Use eye and ear protection.
•
Keep proper footing and balance at all times.
•
Wear security gloves and shoes when handling the ramps.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
•
warranty. Do not exceed the maximum capacity.
Always be careful. Do not use the ramp if you are tired.
•
Check the ramp for stress fractures and breakage before every use. All damaged parts must be replaced by
•
a qualified technician.
Only use original spare parts to replace parts or accessories. Using other parts will void the warranty. Only
•
use spare parts that are meant to be used with this device.
• All loading and unloading must be done on a flat, level, dry surface. Make sure the flange faces down and
the tongue edge fully contacts the tailgate or bed of vehicle.
Make sure the ramp is clean of dirt, debris, grease and oil.
•
Make sure all parts are included in the package when unpacking.
•
3. Assembly
Refer to the illustrations on page 2 of this manual.
4. Use
Make sure no persons or animals are under the ramp or truck bed during the loading process.
•
Never load a vehicle while its engine is running. Let the vehicle cool down before loading it.
•
Never exceed the ultimate limit state. Load the vehicle slowly. Do not drop load onto ramp. This may
•
reduce load capacity and possibly lead to personal injury and /or property damage. All loading and
unloading must be done on a flat, level, dry surface.
5. Loading a Motorcycle (3 persons)
Make sure the ramp is clean of dirt, debris, grease and oil.
•
V. 01 – 27/04/2015
TL73102

USER MANUAL

3 ©Velleman nv