Toolland TL73102 Mode D'emploi page 4

• The tongue edge must face down fully and touch the tailgate of the truck.
• Position a person on each side of the motorcycle. Each person should hold either the front handlebar or the
front fork, where they can steer/guide the vehicle.
They should position their other hand toward the rear of the seat or the rear fork. The third person can
•
start the process from the rear, by pushing, then move to the inside of the truck bed to take control of the
motorcycle when it enters the truck bed.
• Put motorcycle in neutral.
• As the motorcycle contacts the ramp, make sure the ramp remains straight, and the tongue edge remains
in contact with the truck bed. If not, roll back and slowly start over.
6. Technical Specifications
dimensions unfolded
dimensions closed
maximum load closed
ultimate limit state
working load
nominal load
7. Cleaning and maintenance
Make sure the ramp is clean of dirt, debris, grease and oil.
•
Periodically check the ramp for stress fractures and breakage.
•
• Tighten nuts and bolts before each use.
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our website
www.toolland.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 27/04/2015
200 x 25 cm
88 x 25 x 15 cm
1100 kg
350 kg
259 kg (safety factor: 1.35)
140 kg (safety factor: 2.5)
TL73102
4 ©Velleman nv