Panasonic TX-43HXW584 Mode D'emploi page 20

Headphone
Reset
Network Menu Content
Network Type
Scan Wireless
Networks
Press WPS on your
wifi router
Internet Speed Test
Advanced Settings
Wake On
Note: For detailed information on the options of this menu refer to the Connectivity section.
Installation Menu Content
Automatic channel
scan (Retune)
Manual channel
scan
Network channel
scan
Analogue fine tune
Satellite Settings
Installation Settings
(optional)
Clear Service List
Select Active
Network
Signal Information
First time installation
Sets headphone volume. This option will not be available if the Headphone/Lineout
option is not set as Headphone.
Please ensure before using headphones that the headphone volume is set to a low
level, to prevent damage to your hearing.
Resets some of the sound settings to factory defaults.
Disable the network connection or change the connection type.
Start a search for wireless networks. This option will be available if the Network Type
is set as Wireless Device.
If your modem/router device has WPS, you can directly connect to it using this option.
Highlight this option and press OK. Go to your modem/router device and press the
WPS button on it to make the connection. This option will be available if the Network
Type is set as Wireless Device.
Start a speed test to check your connection bandwidth. The result will be displayed on
the screen when finished.
Change the IP and DNS configurations of your TV.
Enable or disable this feature by setting it as On or Off.
Displays automatic tuning options. D. Aerial: Searches and stores aerial DVB stations.
D. Cable: Searches and stores cable DVB stations. Analogue: Searches and stores
analogue stations. Satellite: Searches and stores satellite stations.
This feature can be used for direct broadcast entry.
Searches for the linked channels in the broadcast system. D. Aerial: Searches for aerial
network channels. D. Cable: Searches for cable network channels. Satellite: Searches
for satellite network channels.
You can use this setting for fine tuning analogue channels. This feature is not available
if no analogue channels are stored and if currently watched channel is not an analogue
channel.
Displays satellite settings. Satellite list: Displays available satellites. You can Add,
Delete satellites or Edit satellite settings on the list. Antenna installation: You can
change satellite antenna settings and/or start a satellite scan.
Displays installation settings menu. Standby Search (*): Your TV will search for new or
missing channels while in standby. Any new found broadcasts will be shown. Dynamic
Channel Update(*): If this option is set as Enabled, the changes on the broadcasts
such as frequency, channel name, subtitle language etc., will be applied automatically
while watching.
(*) Availability depends on model.
Use this setting to clear channels stored. This setting is visible only when the Country
option is set to Denmark, Sweden, Norway or Finland.
This setting allows you to select only the broadcasts within the selected network to be
listed in the channel list. This feature is available only for the country option of Norway.
You can use this menu item to monitor signal related information such as signal level/
quality, network name etc for available frequencies.
Deletes all stored channels and settings, resets TV to factory settings.
English - 19 -