Güde GSf 300 Mode D'emploi page 34

EnGlISH
30
failure removal
Defect
Engine not starting or stopping
after a short while
Engine not running smoothly
no drive or drive slipping
no or only minimum snow
ejection
machine getting stuck on small
unevenness.
Some snow remaining untreated
on the ground
Snow being thrown backwards
behind the machine
Unsteady running, strong
vibrations
Causes
Too low level of the engine oil
Lack of oil protection has been
activated
Fuel tap closed
Petrol tank empty
Spark plug dirty from oil or
defective
Wrong gas lever position
Spark plug dirty
Air filter dirty
Clutch slipping
Ejection chimney blocked
Milling worm not rotating as the
clutch is slipping
Skid set too low
Skid set too high
Skid set too high
Plough worn out
Components and screwed connec-
tion loosened
GSF 300 - 4 PS
measure
Check the oil level
Add engine oil
5
Open the fuel tap
Add petrol
Clean or replace the spark plug
Correct the settings
Clean the spark plug
Clean or replace the air filter
Adjust the cable
Consult with the customer service
centre
Switch the engine off and clean the
ejection chimney
Adjust the cable
Correct the settings
8
Correct the settings
8
Correct the settings
8
Replace the plough
Switch the engine off and check /
tighten the screwed connection
Replace any damaged parts
Consult with the customer service
centre
17