Publicité
Les langues disponibles
Les langues disponibles
5. Operation
• Switching the carkit on/off
• Turn On:
With the device off, press and hold the
-multifunction button (7) for 4 seconds until
you hear a short tone. The status LED (3) will light
up in blue for about 3 seconds and then flash
blue twice.
• Turn Off:
With the device on, press and hold the
-multifunction button (7) for 4 seconds until you
hear a short tone. The status LED (3) will light up
in red briefly before the device turns off.
• Attachment:
Slide the provided clip (D) into the groove on the
rear of the hands-free set so that you can attach
it to your vehicle's sun shade. Make sure that the
microphone is not covered.
Note
The functions described in this section are only
available for Bluetooth-capable terminal devices.
5.1. Bluetooth pairing
Note – Pairing
• Make sure that your Bluetooth-capable
terminal device is on and Bluetooth is
activated.
• For more information, please refer to the
operating instructions of your terminal device.
• This hands-free set and the terminal device should
not be any further than 1 metre away from each
other. The shorter the distance, the better.
• Ensure that the hands-free set is turned off.
4
• Press and hold the -multifunction button (7) for
approx. 7 seconds until the status LED (3) begins
to alternate red and blue. The hands-free set is
searching for a Bluetooth connection.
• Open the Bluetooth settings on your terminal
device and wait until BTCK-10B appears in the list
of Bluetooth devices found.
• Select BTCK-10B and wait until the hands-free set
is listed as connected in the Bluetooth settings on
your terminal device.
Note – Bluetooth password
Some terminal devices require a password for
establishing a connection with another Bluetooth
device.
• If your terminal device requests a password to
establish the connection, enter 0000.
• You can now use the Hands-Free System.
Note
• If pairing was successful, the status LED (3)
flashes blue every 10 seconds.
• The hands-free set will turn off automatically
after 2 minutes if no device is paired. There
will be two tones and the status LED (3)
will light up in red. Repeat the steps to pair
the devices.
Publicité
