GE AEL24 Série Manuel D'utilisation Et Instructions D'installation page 12

PREPARE THE WINDOW AND INSTALL
5
THE CASE (continues)
CAUTION:
H
To prevent broken glass
or damage to windows,
on vinyl or other similarly
constructed windows,
attach the window
locking bracket to the
window side jamb.
Attach the window locking
bracket with one Type C
screw .
This unit contains two
window locking brackets .
Cut the foam top window gasket to the window
I
width .
J
Stuff the foam
between the glass
and the window
to prevent air and
insects from getting
into the room .
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal .
INSTALL THE AIR CONDITIONER
6
IN THE CASE
Slide the air conditioner into the case by
A
the base pan . Do not push on the controls,
styrofoam air discharge housing or the finned
coils . Make sure the air conditioner is firmly
seated .
Base Pan
Installation Instructions
Vinyl
Wood
Do not press on
these areas—
damage to the unit
may result
12
INSTALL THE AIR CONDITIONER
6
IN THE CASE (continues)
Replace the 1 screw removed earlier, one
B
on each side of the case .
IMPORTANT: THE GROUND SCREWS MUST BE
REINSTALLED TO ENSURE PROPER GOUND.
Reinstall the control to the panel housing by
C
replacing the 2 screws you removed earlier .
Remove Screws
Install Screws
Attach the front grille to the case by inserting the
D
tabs on the grille into the slots on the front top of
the case . Push the grille in .
Replace the screws .
E
Install the filter and the front grille .
F
Plug in the air conditioner .
G