Panasonic CS-RE18SKUA Instructions D'utilisation page 6

How to use
MODE
To select operation mode
AUTO - For your convenience
• During operation mode selection the POWER
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up. The POWER
indicator blinks during this operation.
COOL - To enjoy cool air
• Provides effi cient comfort cooling to suit your
needs.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
FAN - To circulate air in the room
POWERFUL/
To switch between
QUIET
powerful & quiet
POWERFUL QUIET
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
Can be activated in all modes and can be
cancelled by pressing the respective button again.
Auto OFF/ON button
6
ACXF55-00760_SS1015-0.indb 6 ACXF55-00760_SS1015-0.indb 6
NORMAL
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to
use in normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release to
use in forced HEAT mode.
• Press the button again to turn off.
Remote control display
AUTO
FAN
SPEED
HEAT
COOL
DRY
AIR
SWING
FAN
OFF/ON OFF/ON
MODE
TEMP TEMP
POWERFUL/ /
AIR SWING
QUIET FAN SPEED
TIMER TIMER
ON ON SET SET
1 1 3 3
2 2
OFF OFF CANCEL CANCEL
AC RC
SET CHECK CLOCK CHECK RESET
Remote control receiver
and indicator
(Green)
POWER
(Orange)
TIMER
(Orange)
POWERFUL
(Orange)
QUIET
Press and hold for
approximately
10 seconds to show
temperature setting in
°F or °C.
Press and hold for
approximately
5 seconds to show
12-hour (am/pm) or
24-hour time indication.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
07/01/2016 9:25:45 AM 07/01/2016 9:25:45 AM