ETNA KIS060ZT Mode D'emploi page 31

ERRORS
Symptom
A fuse blows as soon as the
hob is switched on.
Error code ER03.
Error code E3.
Error code E2.
Fault code E6.
Other fault codes.
Possible cause
The appliance is incorrectly
connected.
The control panel is dirty or
has water on it.
Unsuitable pan used.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Defective generator.
Solution
Check the electrical
connections.
Clean the control panel.
Use a pan suitable for
induction cooking.
The appliance has been
switched off because of over
heating.
Have your connection
changed.
Contact the service
department.
EN 15