Pairing The Wireless Subwoofer With The Main Unit; Automatic Pairing; Manual Pairing - Akai TB342-47 Manuel D'utilisation

Pairing the Wireless Subwoofer with the Main Unit

Automatic pairing

The subwoofer and soundbar will automatically pair when both units are plugged into the mains
sockets and turned on. No cable is needed for connecting the two units.
• When the subwoofer is pairing with the main unit, the Pair Indicator will flash.
• When the subwoofer is paired with the main unit, the Pair Indicator will light up.
NOTE:
- Do not press the Pair button on the rear of the subwoofer, except for manual pairing.
- If the automatic pairing fails, pair the subwoofer with the main unit manually.

Manual pairing

1. Ensure that all the cables are well connected and the main unit is in Standby mode.
2. Press and hold the Pair button on the rear of the subwoofer for a few seconds. The subwoofer
will enter the pairing mode and the Pair Indicator will blink quickly.
/SOURCE button on the main unit or the
3. Press the
the main unit on.
4. After the wireless connection succeeded, the Pair Indicator will light up.
5. If the Pair indicator blinks, the wireless connection has failed. Unplug the cable of the
subwoofer and then reconnect the main cable after 3 minutes. Repeat step 1 ~ 4.
NOTE:
1 If the wireless connection fails again, check if there is conflict or strong interference (for
example, interference from an electronic device) around your location. Remove these conflicts
or strong interferences and repeat the above procedures.
2 The subwoofer should be within 6m of the soundbar in an open area.
3 If a TV or an external device is connected, the main unit and the subwoofer will switch on
automatically when the TV or the external device is switched on.
4 If the TV or the external unit is disconnected or switched off, the main unit and the subwoofer
will switch off automatically after 15 minutes.
5 If the volume on the TV or an external device is too low, the main unit and the subwoofer will
switch off after 15 minutes.
6 If the main unit is not connected with the subwoofer and it is in On mode, the POWER Indicator
will flash. Follow step 1 ~ 4 above to pair the subwoofer to the main unit.
button on the remote control to switch
28