Samsung WF50K7500A Manuel De L'utilisateur page 17

Drain
Samsung recommends a standpipe 18
in (46 cm) high. The drain hose must be
connected through the hose clip to the
standpipe, and the standpipe must fully
cover the drain hose.
Flooring
For best performance, the washer must
be installed on a solid floor. Wood floors
may need to be reinforced to minimize
vibration and/or unbalanced loads.
Carpeting and soft tile surfaces do not
provide good resistance to vibrations and
may cause the washer to move slightly
during the spin cycle.
CAUTION
Do NOT install the washer on a platform or
a poorly supported structure.
Water temperature
Do not install the washer in areas where
water may freeze as the washer always
retains some water in its water valves,
pumps, and/or hoses. Frozen water left in
the connection parts may cause damage to
belts, the pump, and other components of
the washer.
WF7500K-DC68-03667A-03_EN.indd 17
Alcove or closet installation
Minimum clearance for stable operation:
Sides
Top
Rear
Front
If both the washer and a dryer are
installed in the same location, the front of
the alcove or closet must have at least a
72 in² (465 cm²) unobstructed air opening.
Your washer alone does not require a
specific air opening.
1 in. (25 mm)
17 in. (432 mm)
5.9 in. (150 mm)
2 in. (51 mm)
English 17
2018/1/8 11:03:11